Now that I have had time to play around more that the valley of death job is done, I have put together a new 'to do' list. Some of these jobs are easy, some a tiny bit more complicated...

(1) Tackle the engine rough start issue. This can be attributed to several things, so I am going to do the following:
- Replace the Thermo-Time Switch
- Clean battery grounds
- Check all circuitry in the cold start/hot start circuit
- Possibly replace warm up regulator if still running rough
- Possibly replace the fuel accumulator if still running rough
- Replace fuel filter and 02 sensor

(2) Fix both doors:
- Adjust passenger side hinges so door shuts flush
- Fix drivers side front latch so it actually works
- Replace fir-tree connectors in door panels so they fit more flush
- Replace foam around passenger side bottom door panel as it is ripping

(3) Complete the following misc. stuff:
- Torque rear frame bolts
- Paint louvers with SEM Trim Black
- Rebuild mode switch
- Fix glove box light
- Possibly take torsion bars down one notch
- Finish using leatherique on both seats
- Possibly redye leather seats
- Remove valve covers, paint, & replace gaskets
- Adjust air conditioning cycling
- Touch up frame rust with POR-15